Posted on:

Share this:

Back to latest news

Posted on:

The most common pitfalls to avoid when reseeding

Reseeding is expensive, costing around €250–350/ac, but when done correctly it can pay for itself in two years – which is a very quick return on investment. Germinal’s Dr. Mary McEvoy highlights some of the most common pitfalls to avoid when reseeding, to give your new reseed the best chance to successfully establish.

Avoiding these will give a much better chance of successful establishment of a high–performing sward for years to come. Poor seedbed preparation, where inadequate soil–seed contact is created is probably the greatest risk to good sward establishment.

Poor kill of old sward

Desiccation or killing off the old sward is an essential first step when reseeding and the only opportunity you will have to control grass weeds in the sward. It also presents an ideal opportunity to destroy difficult weeds such as docks, thistles and other grass weeds.
Applying glyphosate, as per the product label, and the recommended water volume is essential to achieve successful desiccation of the old sward. Using higher or lower water volume than recommended will reduce the effectiveness of the product.

About 7–10 days after spraying, the sward should be grazed or cut tightly to minimise the surface trash.

Allow the product adequate time to work. For min–till operations, the recommendation would be 16–20 days from spraying to cultivation. This will ensure the herbicide has adequate time to translocate to the roots and kill the plant in its entirety.

Poor seedbed preparation

Cloddy seedbed

A cloddy seedbed occurs as a result of cultivating too soon after spraying the old sward or inadequate preparation of the seedbed. A cloddy seedbed results in poor soil–to–seed contact and a seedbed which will dry out quickly.

Allowing adequate time for the herbicide to kill the roots is essential to ensure the roots are destroyed and will avoid clods in the seedbed.

For min–till, as explained above, this can take 16–20 days.

Cloddy Pitfall

 

Cloddy Pitfall 2


Soft seedbed

A soft, loose or ‘fluffy’ seedbed can occur if the soil is overworked and is often seen when too many passes of the disc harrow or power harrow occur. Avoiding this is essential, as the seed will get buried too deep and poor establishment will occur. An old rule is; you should be able to cycle a bike across the seed bed before the seed is sown, so roll prior to sowing if necessary to firm it up.
Using an experienced contractor will also help avoid the risk of this occurring.

Inadequate rolling – Plant pulling and moisture loss

Rolling is essential to create good soil–to–seed contact and it also helps maintain moisture within the seedbed. Often plants emerge quickest where the tractor wheel marks are; this is a sure sign the field was inadequately rolled and a common issue seen with new reseeds.

Pitfall Three

Soil fertility issues

No lime applied

Lime at sowing is essential. As the old sward decays, it releases acids which lower the pH and create a difficult environment for the new seed trying to germinate. Using either ground lime or bagged lime will help counteract this acidity and is essential, even if your soil pH is already good.

Poor soil fertility status

As the new seed germinates it requires Phosphorous (P) and Potassium (K), which are essential for root and tiller development as the new plants emerge. Insufficient P and K will result in poor establishment and a weak sward. Apply P and K as per soil test results.

Grass seed

It makes poor economic sense to go to the effort and cost of reseeding and then use poor grass seed mixtures. The seed you sow today is expected to perform for 10 years and maybe longer, so it is worth sowing the best grass varieties currently available.

Only sow mixtures which contain varieties that are on the Department of Agriculture Recommended List and the Teagasc Pasture Profit Index (PPI) list.

Using the best performing varieties off the PPI will ensure a greater return from your swards year after year. AberGain is the leading variety overall on the Teagasc PPI in 2019, it is also the highest quality variety available, while AberChoice is the leading late diploid and the highest quality diploid overall for 2019.

 

Pitfall 4

Share this:

Accessing our website tells us you are happy to receive all our cookies. However you can change your cookie settings at any time. Find out more